Assembly instructions: adhesive lettering & adhesive letters

Stick on adhesive lettering / adhesive letters correctly with transfer foil: Our adhesive lettering is punched out of coloured foils. A transfer foil holds all letters and characters together so that each letter does not have to be stuck on individually.

1. unpacking

You will receive your foil rolled up, padded with bubble wrap in one package. Roll it out and lay it flat on a flat surface.

2. prepare

Swipe firmly over the surface to press all the letters back onto the transfer foil. Repeat this also on the back side. All letters now stick to the transfer foil.

3. fix the foil

Fix the film in the correct position with a strip of adhesive tape (e.g. Sellotape, masking tape on the upper edge.
You can check the position e.g. with a yardstick.

4. fold down the foil

Fold the entire film upwards so that the motif is upside down. You can now see the back of the foil (the backing paper).

5. remove backing paper

Remove the backing paper at an acute angle. You now expose the sticky side. (If letters do not yet stick to the transparent transfer foil, paint it again).

6. fold down the foil

Fold the film back down. Make sure that the adhesive foil does not stick unintentionally. Hold it taut and lay it flat on the surface.

7. apply adhesive foil

Now stroke firmly and evenly over the transfer film from top to bottom with a squeegee or similar application aid. This way you press the letters with the adhesive side against the surface.

8. remove transfer foil

Now carefully (not too fast) remove the transparent transfer foil again. Make sure that all letters detach from the transfer foil and adhere to the surface.

9. ready

Ready! Make sure that all letters stick well and your lettering is ready!